1、環境溫度控制要求

1. Environmental temperature control requirements

高壓羅茨鼓風機的安裝環境溫度必須嚴格控制在40攝氏度以下。這一溫度限制是基于設備安全運行的考慮，當環境溫度超過此限值時，風機吸入的空氣溫度將顯著升高，導致排出空氣溫度超出安全范圍。對于常規型號的羅茨鼓風機而言，持續高溫運行會嚴重影響設備壽命，甚至可能引發安全隱患。因此，在高溫環境安裝時，必須采取有效的降溫措施或考慮選用特殊耐高溫型號。

The installation environment temperature of high-pressure Roots blower must be strictly controlled below 40 degrees Celsius. This temperature limit is based on the consideration of safe operation of the equipment. When the ambient temperature exceeds this limit, the temperature of the air sucked in by the fan will significantly increase, resulting in the exhaust air temperature exceeding the safe range. For conventional Roots blowers, continuous high temperature operation can seriously affect equipment life and even pose safety hazards. Therefore, effective cooling measures must be taken or special high-temperature resistant models must be considered for installation in high-temperature environments.

2、環境潔凈度標準

2. Environmental Cleanliness Standards

高壓羅茨鼓風機作為清潔空氣輸送設備，對安裝環境的潔凈度有嚴格要求。工作環境中若存在大量粉塵污染物，將導致以下問題：首先，粉塵被吸入后會快速堵塞空氣過濾器，造成系統阻力增大，影響風機性能；其次，較大顆粒物進入風機腔體后，會與高速旋轉的葉輪發生摩擦，造成葉輪表面嚴重磨損，不僅降低設備效率，還會縮短使用壽命。因此，安裝場地必須保持整潔，必要時可增設前置過濾裝置。

As a clean air conveying equipment, high-pressure Roots blowers have strict requirements for the cleanliness of the installation environment. If there is a large amount of dust pollutants in the work environment, it will lead to the following problems: firstly, the dust will quickly clog the air filter after being inhaled, causing an increase in system resistance and affecting the performance of the fan; Secondly, larger particles entering the fan chamber will rub against the high-speed rotating impeller, causing severe wear on the impeller surface. This not only reduces equipment efficiency but also shortens its service life. Therefore, the installation site must be kept clean, and if necessary, pre filtration devices can be added.

3、基礎建設規范

3. Infrastructure construction standards

為確保設備穩定運行，高壓羅茨鼓風機必須安裝在專用水泥地基上。該地基應滿足以下技術要求：高度需超出地面約20厘米，以提供良好的防潮性能；基礎螺栓孔位必須嚴格按照設備圖紙預留，確保安裝精度；基礎質量要達到規定強度標準。這種專業基礎設計具有雙重作用：一是牢固固定設備，防止位移；二是有效吸收和緩沖設備運行時的振動，降低噪音并延長使用壽命。

To ensure stable operation of the equipment, the high-pressure Roots blower must be installed on a dedicated cement foundation. The foundation should meet the following technical requirements: the height should exceed the ground by about 20 centimeters to provide good moisture resistance; The basic bolt holes must be strictly reserved according to the equipment drawings to ensure installation accuracy; The basic quality must meet the specified strength standards. This professional basic design has a dual function: firstly, to firmly fix the equipment and prevent displacement; The second is to effectively absorb and buffer the vibration during equipment operation, reduce noise, and extend service life.

4、設備間距要求

4. Equipment spacing requirements

在多臺風機并聯安裝的情況下，必須保證足夠的設備間距。這個間距需要滿足兩個基本要求：首先，要為日常維護和檢修作業提供充足的操作空間，確保維護人員能夠安全、便捷地進行各項操作；其次，要保證設備周圍的空氣流通順暢，避免因間距過小導致的散熱不良問題。合理的間距設計是確保設備群高效穩定運行的重要前提。

In the case of parallel installation of multiple wind turbines, sufficient equipment spacing must be ensured. This spacing needs to meet two basic requirements: firstly, it should provide sufficient operating space for daily maintenance and repair operations, ensuring that maintenance personnel can safely and conveniently carry out various operations; Secondly, it is necessary to ensure smooth air circulation around the equipment to avoid poor heat dissipation caused by small spacing. Reasonable spacing design is an important prerequisite for ensuring efficient and stable operation of equipment groups.

5、噪音控制區域規劃

5. Noise control area planning

鑒于高壓羅茨鼓風機運行會產生較大噪音，其安裝位置的選擇必須考慮噪音污染控制。設備應遠離居民區、辦公區等對噪音敏感的區域。在選址規劃時，需要評估噪音傳播途徑，必要時采取隔音措施。這一要求不僅關系到環境保護，也是企業履行社會責任的重要體現。

Given that the operation of high-pressure Roots blowers generates significant noise, the selection of their installation location must consider noise pollution control. The equipment should be kept away from noise sensitive areas such as residential and office areas. When selecting a site for planning, it is necessary to evaluate the pathways of noise transmission and take sound insulation measures if necessary. This requirement is not only related to environmental protection, but also an important manifestation of corporate social responsibility.

6、設備防護措施

6. Equipment protection measures

高壓羅茨鼓風機必須避免直接暴露在戶外環境中。理想的安裝場所是專用機房，如條件受限，至少應搭建具有防雨防曬功能的防護棚。長期暴露在自然環境中會導致以下問題：風雨侵蝕加速設備老化；陽光直射引起溫度升高；灰塵和異物進入設備內部。完善的防護措施可顯著延長設備使用壽命，降低故障率。

High pressure Roots blowers must avoid direct exposure to outdoor environments. The ideal installation location is a dedicated computer room. If conditions are limited, at least a protective shed with rain and sun protection functions should be built. Long term exposure to the natural environment can lead to the following problems: accelerated aging of equipment due to wind and rain erosion; Direct sunlight causes an increase in temperature; Dust and foreign objects enter the interior of the equipment. Comprehensive protective measures can significantly extend the service life of equipment and reduce the failure rate.

本文由高壓羅茨鼓風機友情奉獻.更多有關的知識請點擊:http://www.baihengnewenergy.com我們將會對您提出的疑問進行詳細的解答，歡迎您登錄網站留言.

This article is a friendly contribution from the pneumatic conveying system For more information, please click: http://www.baihengnewenergy.com We will provide detailed answers to your questions. You are welcome to log in to our website and leave a message